Garage Door Spring Replacement in San Antonio
A loud bang from the garage and a door that suddenly weighs a ton means a spring has broken. It is the most common garage door repair and one of the quickest for a technician to finish. Send us your ZIP code and door size and we will pass your request to independent companies that replace springs in the San Antonio area.
Typical price: $150 to $350 to replace both torsion springs, $120 to $200 for extension springs, $300 to $600 on a double door. Source: HomeGuide national averages, updated October 2025. Parts and labor included. These are not quotes; the installing company sets the price.
Updated November 2026
Do not replace a torsion spring yourself. A wound torsion spring stores enough energy to lift the whole door. If a winding bar slips or a set screw is loosened in the wrong order, that energy goes into the bar, your hands or your face. HomeGuide's cost guide carries the same warning: attempting it can result in serious injury or death. Until a technician arrives, leave the opener unplugged or off, keep the door closed if you can, and keep kids away from it.
How to tell the spring is broken
- A bang like something heavy fell. People often think a shelf collapsed or something hit the house.
- A visible gap in the coil. Look at the spring on the bar above the closed door. A break shows as a one to two inch space between coils.
- The opener strains and stops. It lifts the door a few inches, then reverses or quits. The safety logic is doing its job.
- The door is too heavy to lift by hand, or it will not stay halfway and drops.
- Loose cables. With no spring tension, the lift cables go slack and can slip off the drums.

If the door has two springs and only one broke, the door may still move, badly. Running it that way overloads the second spring and the opener.
Spring replacement prices by spring and door type
| Job | Typical price, parts and labor |
|---|---|
| Torsion spring replacement | $150 to $350 |
| Torsion spring and bar | $200 to $400 |
| Extension spring replacement | $120 to $200 |
| Springs and cables together | $200 to $500 |
| Insulated door (heavier springs) | $250 to $400 |
| Double door | $300 to $600 |
| Carriage-style door | $200 to $450 |
| Convert extension springs to torsion | $400 to $800 or more |
Source: HomeGuide, garage door spring replacement cost. National averages; we have not surveyed San Antonio companies yet.
Advertised prices can sit below these ranges. Thumbtack's San Antonio page shows one spring repair starting at $99 and another starting at $185, where the $185 broke down into $40 for travel, $60 for parts and $85 an hour for labor. A low starting price usually covers one standard spring on a light single door, so ask what your door will cost with its size and weight.
For a fuller breakdown, read our garage door spring replacement cost guide for San Antonio.
Torsion or extension: which do you have?
Torsion springs
One or two tightly wound springs on a steel bar mounted on the wall above the door. They twist to lift. This is the standard setup on sectional doors in newer San Antonio subdivisions. Expected life is 10,000 to 20,000 cycles, roughly 7 to 14 years in a typical home.
Extension springs
Long springs that run along the horizontal tracks on each side and stretch as the door closes. More common on older and single-panel doors. Expected life is 5,000 to 15,000 cycles, roughly 4 to 10 years. They should have a safety cable threaded through them so a broken spring cannot fly across the garage.
A cycle is one open and one close. A household that uses the garage as its front door, with two drivers and kids coming and going, can run through 10,000 cycles much faster than the averages suggest. That is the case for asking about high-cycle springs.
Questions to ask before you approve the work
- Are you replacing both springs? On a two-spring door, both have done the same number of cycles. Replacing the pair in one visit is standard and avoids a second service call a few months later.
- How was the spring sized? The right spring is chosen from the door's weight and height, plus the wire size, inside diameter and length of the old spring. A technician who weighs the door or measures the old spring is doing it properly.
- What cycle rating is the new spring? Standard springs are rated around 10,000 cycles. Higher-cycle springs cost more and last longer.
- Is the price for parts and labor, and is the service fee included?
- Will you check the cables, drums, bearings and door balance? A balanced door stays put when you lift it halfway by hand and let go.
- What is the warranty on the springs and on the labor? Ask for it in writing on the invoice.
If the cables are frayed or came off when the spring broke, they are usually replaced in the same visit. See garage door cable repair.
Making the new springs last
Springs fail from fatigue and from rust. A garage in South Texas goes from a long, hot summer to the occasional hard freeze, and metal that is already near the end of its cycle life tends to let go on the first cold morning. You cannot stop fatigue, but you can slow the rest:
- Spray the coils with a garage door lubricant once or twice a year. It cuts friction between coils and keeps surface rust off.
- Test the balance every few months: pull the red release cord with the door closed, lift the door to waist height and let go. If it drifts down or shoots up, the springs need adjusting by a technician.
- Have the door looked at once a year. HomeGuide puts annual spring maintenance at $40 to $80 and a full tune-up at $100 to $250.

Spring replacement questions
How much does garage door spring replacement cost in San Antonio?
HomeGuide's national averages are $150 to $350 to replace torsion springs and $120 to $200 for extension springs, with double doors running $300 to $600. Quotes in San Antonio depend on door size, weight and spring quality, so ask for a written price that includes parts, labor and the service fee.
Can I replace a garage door spring myself?
It is not a safe do-it-yourself job. Torsion springs are wound under high tension and can cause serious injury if a winding bar slips or hardware is loosened in the wrong order. Extension springs can whip when released. Hire a trained technician.
Should both springs be replaced at the same time?
Yes, on a door with two springs. Both springs have gone through the same number of cycles, so the second one is close to failing when the first breaks. Replacing the pair costs less than two separate visits and keeps the door balanced.
How long does it take to replace garage door springs?
For a standard residential door, the replacement itself is usually done in a single visit of about an hour or two once the technician has the right springs. Unusual door sizes or heavy custom doors can require ordering springs.
How long do garage door springs last?
Torsion springs typically last 10,000 to 20,000 cycles, or about 7 to 14 years in most homes. Extension springs last about 5,000 to 15,000 cycles, or 4 to 10 years. Heavy daily use shortens that.
My car is stuck in the garage. What should I do?
Tell the company your car is trapped when you request service so they can treat it as urgent. Do not force the door open with the opener, and do not try to lift it alone. With a broken spring you would be lifting the full weight of the door and it can fall.
Do you replace the springs yourselves?
No. We are a free referral service. We forward your request to independent garage door companies serving the San Antonio area, and the company you hire does the work and provides any warranty.
Related garage door services
Garage door repair
Anything that keeps the door from opening, closing or staying quiet.
Cable repair
Frayed, slack or snapped lift cables and worn drums.
Emergency repair
Car trapped inside, door stuck open, or a door that won't lock.
See all garage door services, the areas around San Antonio we cover, or our cost guides.
Broken spring? Get a price before the visit
Tell us whether the door is single or double and whether your car is stuck inside. We forward the request to independent garage door companies serving your ZIP code. It is free and you are not obligated to hire.